XADO技术,通过正常使用条件下在金属摩擦副表面原位生成金属陶瓷层,实现对各种机械设备和车辆的免拆精修、节能环保改造、延长寿命处理等。
保护型润滑脂
多功能润滑脂 内含XADO再生剂
修复10%的磨损
详细说明:
产品简介:
XADO保护型润滑脂用于大负载机械设备的保护,防止摩擦表面磨损。它能消除新造滚动轴承的制造缺陷;延长零部件使用寿命2-4倍。
XADO保护型润滑脂是普通多用途锂基润滑脂的替代品。这一现代配方技术润滑脂拥有国际发明专利,其中含有“摩圣”再生剂和EP(Extreme Pressure)极压添加剂。
主要功效:
1、延长设备使用寿命;
2、修复不超过10%的磨损;
3、消除划痕和微裂纹;
4、降低振动和噪音;
5、降低表面粗糙度Ra至8纳米;
6、节约电能消耗。
使用方法:
使用专用加油枪加注时,通过油枪口直接将润滑脂挤入所要润滑的设备,直至润滑脂到达润滑部位的空隙为止;
手工涂抹时,先清除旧润滑脂,然后用新润滑脂填充轴承空腔至一半即可。
备注:
该润滑脂的特长是对轴承提供抗磨损保护(转速10 000r/min);
建议用于新的轴承或者其它零部件;
可与各种汽车或者工业设备锂基润滑脂混合使用,比例不限。
技术指标:
外观颜色 ┉┉┉ 橙色
NLGI 稠度级别 ┉┉┉ 3
点滴温度,℃ ┉┉┉ >189
25℃时针入度,mm-1 ┉┉┉ 257
120℃时蒸发度,% ┉┉┉ <0.2
工作温度,℃
长期 ┉┉┉ <130
短时间 ┉┉┉ <150
四球机上的润滑性能试验数据(20±5℃):
粘结荷载,N ┉┉┉ >2450
极限荷载,N ┉┉┉ >1039
磨损系数,mm ┉┉┉ <0.6
备注:上表中仅列典型参数
标准:
NLGI 3 (ASTM D217)
ISO-L-XBCEB 3 (ISO 6743-9)
KP3K-20(DIN 51502)
包装:
400毫升:气雾剂罐;
Grease 'Protective'
XADO Grease Protective is applied for protection of units and mechanisms operating under heavy loads. This grease is a universal substitute for all consistent greases and protects surfaces from wear. Removes factory defects of new frictionless bearings. Extends the life span of the parts considerably.
Advantages
Technical characteristics
The patented formula of this up-to-date grease is based on a composition of XADO revitalizant and EP complex (Extreme Pressure).
Method of application:
Remove the old grease.
Fill 1/2 of unit volume with PROTECTIVE grease XADO.
Note.
The grease is especially effective for protection of bearings from wear (up to 10,000.00 rpm).
Recommended for new assemblies and parts.
Colour: from biscuit to orange
Thickener/Base Oil: Li-soap/Mineral Oil
Penetration: 195-250
Category temperature range °C: -40...+120
Advantages
- extends life span of joints;
- compensates 10% wear;
- restores scratches and microcracks;
- reduces noise and vibration;
- improves the treatment coefficient Ra up to 0,06 mkm;
- rejects heat from friction area;
- protects units from hostile environment.
Technical characteristics
The patented formula of this up-to-date grease is based on a composition of XADO revitalizant and EP complex (Extreme Pressure).
Method of application:
Remove the old grease.
Fill 1/2 of unit volume with PROTECTIVE grease XADO.
Note.
The grease is especially effective for protection of bearings from wear (up to 10,000.00 rpm).
Recommended for new assemblies and parts.
Colour: from biscuit to orange
Thickener/Base Oil: Li-soap/Mineral Oil
Penetration: 195-250
Category temperature range °C: -40...+120
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment